🔥🔥 Don’t Miss Out on Our End of Autumn Sale. If you have any questions, feel free to click the bottom right corner to contact our customer service..

Concat us[email protected]
Shopping Cart

No products in the cart.

🔍
ASTM-A193:2008 Edition

ASTM-A193:2008 Edition

$44.96

A193/A193M-08 Standard Specification for Alloy-Steel and Stainless Steel Bolting Materials for High Temperature or High Pressure Service and Other Special Purpose Applications

Published By Publication Date Number of Pages
ASTM 2008 13
PDF Format Searchable Printable Preview Now
Guaranteed Safe Checkout
Categories: , ,

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

1.1 This specification covers alloy and stainless steel bolting material for pressure vessels, valves, flanges, and fittings for high temperature or high pressure service, or other special purpose applications. The term bolting material as used in this specification covers bars, bolts, screws, studs, stud bolts, and wire. Bars and wire shall be hot-wrought. The material may be further processed by centerless grinding or by cold drawing. Austenitic stainless steel may be carbide solution treated or carbide solution treated and strain-hardened. When strain hardened austenitic steel is ordered, the purchaser should take special care to ensure that Appendix X1 is thoroughly understood.

1.2 Several grades are covered, including ferritic steels and austenitic stainless steels designated B5, B8, and so forth. Selection will depend upon design, service conditions, mechanical properties, and high temperature characteristics.

Note 1The committee formulating this specification has included fifteen steel types that have been rather extensively used for the present purpose. Other compositions will be considered for inclusion by the committee from time to time as the need becomes apparent.

Note 2For grades of alloy-steel bolting material suitable for use at the lower range of high temperature applications, reference should be made to Specification A 354 .

Note 3For grades of alloy-steel bolting material suitable for use in low temperature applications, reference should be made to Specification A 320/A 320M .

1.3 Nuts for use with this bolting material are covered in Section 14.

1.4 Supplementary Requirements S1 through S10 are provided for use when additional tests or inspection are desired. These shall apply only when specified in the purchase order.

1.5 This specification is expressed in both inch-pound units and in SI units. However, unless the order specifies the applicable M specification designation (SI units), the material shall be furnished to inch-pound units.

1.6 The values stated in either inch-pound units or SI units are to be regarded separately as standard. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification. Within the text, the SI units are shown in brackets.

PDF Catalog

PDF Pages PDF Title
1 Scope
Referenced Documents
2 General Requirements and Ordering Information
Common Requirements
Manufacture (Process)
Discard
Heat Treatment
3 TABLE 1
5 TABLE 2
6 TABLE 3
8 Chemical Composition
Heat Analysis
Mechanical Properties
Workmanship, Finish, and Appearance
Retests
9 Test Specimens
Nuts
Rejection and Rehearing
Certification
Product Marking
Keywords
TABLE 4
10 TABLE 5
12 X1. STRAIN HARDENING OF AUSTENITIC STEELS
X1.1
X1.2
X1.3
X2. COATINGS AND APPLICATION LIMITS
X2.1

Related products

ASTM-A193
$44.96