ASTM-B68M 2005
$40.63
B68M-99(2005) Standard Specification for Seamless Copper Tube, Bright Annealed [Metric] (Withdrawn 2011)
| Published By | Publication Date | Number of Pages |
| ASTM | 2005 | 5 |
ASTM B68M-99-Reapproved2005
Withdrawn Standard: Standard Specification for Seamless Copper Tube, Bright Annealed [Metric] (Withdrawn 2011)
ASTM B68M
Scope
1.1 This specification establishes the requirements for bright annealed seamless copper tube suitable for use in refrigeration, oil lines, gasoline lines, and so forth, where tube with an interior surface essentially free from scale and dirt is required.
1.1.1 Tubes made from any of the following Copper UNS No. designations shall be supplied, unless otherwise specified in the contract or purchase order:
Copper UNS No.Type of CopperC10200Oxygen-free without residual deoxidantsC10300Oxygen-free, extra low phosphorusC10800Oxygen-free, low phosphorusC12000Phosphorus deoxidized, low residual phosphorusC12200Phosphorus deoxidized, high residual phosphorus
1.2 Values stated in SI units are the standard.
1.3 This specification is the companion to inch-pound Specification B 68.
The following hazard statement pertains only to the test method described in Sections and of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
bright annealed; copper tube; seamless tube
ICS Code
ICS Number Code 77.150.30 (Copper products)
DOI: 10.1520/B0068M-99R05
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 1 | Scope Referenced Documents Terminology Ordering Information |
| 2 | Materials and Manufacture Chemical Composition Temper Grain Size Mechanical Property Requirements Performance Requirements Microscopical Examination Hydrogen Embrittlement TABLE 1 TABLE 2 |
| 3 | Nondestructive Testing Purchases for U.S. Government Agencies Dimensions and Permissible Variations Workmanship, Finish, and Appearance General Requirements Sampling TABLE 3 TABLE 4 TABLE 5 |
| 4 | Number of Tests and Retests Specimen Preparation Test Methods |
| 5 | Keywords |
