ASTM-C980 2010

$35.75

C980-10 Standard Specification for Industrial Chimney Lining Brick

Published By	Publication Date	Number of Pages
ASTM	2010	3

Guaranteed Safe Checkout

Categories: 91.100.15 - Mineral materials and products, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

1.1 This specification covers solid kiln fired brick made from clay, shale, or mixtures thereof suitable for use in masonry construction in contact with the chemicals present in flue gases found in industrial chimneys. These brick are normally used with chemical-resistant mortars.

1.2 The physical and chemical properties of chimney lining brick differ from supplier to supplier mainly because their composition is determined by the source of raw materials. Chimney lining brick, regardless of these differences, are considered to be of three types noted as follows:

1.2.1 Type I For use where low absorption and high acid resistance are not major factors.

1.2.2 Type II For use where lower absorption and higher acid resistance are required.

1.2.3 Type III For use where lowest absorption and highest acid resistance are required.

Note 1Types I, II, and III may not differ significantly in their resistance to thermal shock, and selection of brick type should be based upon their absorption and acid-resistant service requirements.

1.3 Terminology related to industrial floor brick is found in Terminology C1232 .

1.4 Units The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Sulfuric Acid Boil Test Physical Properties
2	Black Heart Test for Solubility in Sulfuric Acid Keywords TABLE 1 TABLE 2

Additional information

Standard Title	C980-10 Standard Specification for Industrial Chimney Lining Brick
Published Code	ASTM
Publication Date	2010
Pages Count	3
ICS Codes	91.100.15 - Mineral materials and products

Preview PDF


PDF Format	Searchable	Printable	Preview Now

ASTM-C980 2010

PDF Catalog

Related products