ASTM-D228 2005

$44.96

D228-05 Standard Test Methods for Sampling, Testing, and Analysis of Asphalt Roll Roofing, Cap Sheets, and Shingles Used in Roofing and Waterproofing

Published By	Publication Date	Number of Pages
ASTM	2005	13

Guaranteed Safe Checkout

Categories: 91.100.60 - Thermal and sound insulating materials, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM D228-05

Historical Standard: Standard Test Methods for Sampling, Testing, and Analysis of Asphalt Roll Roofing, Cap Sheets, and Shingles Used in Roofing and Waterproofing

ASTM D228

Scope

1.1 These test methods include procedures for sampling, examination, physical testing, and analyses of asphalt-containing materials used in roofing and waterproofing. These materials include but are not limited to roll roofing, cap sheets, and shingles. Any of these materials are allowed to be partially or fully coated, surfaced, or laminated, or combination thereof.

1.2 The test methods and procedures in this standard appear in the following order:

1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

analysis; asphalt; cap sheets; composition; physical testing; roll roofing; sampling; shingles

ICS Code

ICS Number Code 91.100.60 (Thermal and sound insulating materials)

DOI: 10.1520/D0228-05

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents
2	Terminology FIG. 1
3	Significance and Use Types of Roofing Sampling As Received Mass and Area Determinations, All Types of Roofing
4	Selection of Representative Specimens, All Roofing Types FIG. 2
5	Moisture Pliability Mass Loss and Behavior on Heating Tear Strength
6	Fastener Pull-Through Resistance
7	FIG. 3 FIG. 4
8	Preparation and Selection of Small Specimens for Analyses Analysis of Glass Felt Products
9	Analysis of Roofing Products with Organic Felts FIG. 5 FIG. 6
10	FIG. 7
11	Ash of Desaturated Felt Calculation
12	Adjusting Back Coating Fine Mineral Matter and Back Surfacing Report Precision and Bias FIG. 8
13	Keywords TABLE 1

Additional information

Section	Content
21	Precision and Bias
10	Pliability
20	Report
9	Moisture
8	Selection of Representative Specimens
7	Mass and Area Determination
6	Sampling
5	Types of Roofing
19	Adjusting Back Coating Fine Mineral Matter and Back Surfacing
18	Calculation
17	Ash of Desaturated Felt
16	Analysis of Roofing Products with Organic or Asbestos Felts
15	Analysis of Glass Felt Products
14	Preparation and Selection of Small Test Specimens for Analyses
13	Fastener Pull-Through Resistance
12	Tear Strength
11	Mass Loss and Behavior on Heating

ICS Codes	91.100.60 - Thermal and sound insulating materials