ASTM-D3464 1996
$35.75
D3464-96 Standard Test Method for Average Velocity in a Duct Using a Thermal Anemometer
| Published By | Publication Date | Number of Pages |
| ASTM | 1996 | 4 |
ASTM D3464-96
Historical Standard: Standard Test Method for Average Velocity in a Duct Using a Thermal Anemometer
ASTM D3464
Scope
1.1 This test method describes the measurement of the average velocity with a thermal anemometer for the purpose of determining gas flow in a stack, duct, or flue (1-5). It is limited to those applications where the gas is essentially air at ambient conditions and the temperature, moisture, and contaminant loading are insignificant as sources of error compared to the basic accuracy of the typical field situation.
1.2 The range of the test method is from 1 to 30 m/s (3 to 100 ft/s).
1.3 The values stated in SI units are to be regarded as the standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
air velocity; anemometer; atmospheres; gas velocity; hot wire anemometer; measurements; pitot tube; thermal anemometer
ICS Code
ICS Number Code n/a
DOI: 10.1520/D3464-96
