ASTM-D4806 2011
$40.63
D4806-11a Standard Specification for Denatured Fuel Ethanol for Blending with Gasolines for Use as Automotive Spark-Ignition Engine Fuel
Published By | Publication Date | Number of Pages |
ASTM | 2011 | 7 |
1.1 This specification covers nominally anhydrous denatured fuel ethanol intended to be blended with unleaded or leaded gasolines at 1 to 10 volume % for use as automotive spark-ignition engine fuel covered by Specification D4814 . The significance of this specification is shown in Appendix X1.
1.2 The user is advised to check with the national regulatory agencies where the ethanol is denatured and used. The sulfur limit and denaturing formulas in this specification are acceptable for the U.S. market. Other countries or jurisdictions may allow or require other denaturing formulas and sulfur limits.
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.4 The following safety hazards caveat pertains only to the method modification in 8.7 of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
PDF Catalog
PDF Pages | PDF Title |
---|---|
1 | Scope Referenced Documents |
2 | Terminology Denaturants TABLE 1 |
3 | Workmanship TABLE 2 |
4 | Sampling, Containers, and Sample Handling Test Methods Keywords |
5 | X1. SIGNIFICANCE OF SPECIFIED PROPERTIES X1.1 Denatured Fuel Alcohol |
6 | X2. CALIFORNIA ETHANOL REQUIREMENTS X2.1 California Ethanol Requirements X3. IRS NOTICE 2009ā06, āCALCULATION OF VOLUME OF ALCOHOL FOR FUEL CREDITS; DENATURANTSāĀ X3.1 TABLE X2.1 TABLE X2.2 |