ASTM-D5485 2011

$44.96

D5485-11 Standard Test Method for Determining the Corrosive Effect of Combustion Products Using the Cone Corrosimeter

Published By	Publication Date	Number of Pages
ASTM	2011	14

Guaranteed Safe Checkout

Categories: 13.040.40 - Stationary source emissions, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

1.1 This fire-test-response standard measures the corrosive effect by loss of metal from the combustion products of materials, components, or products.

1.2 This test method provides corrosion results of product and material specimens limited to a maximum size of 100 by 100 mm in area and 50 mm thick.

1.3 The results of this test method have not been investigated with respect to correlation to actual fires.

1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. (See )

1.5 This standard measures and describes the response of materials, products, or assemblies to heat and flame under controlled conditions, but does not by itself incorporate all factors required for fire hazard or fire risk assessment of the materials, products, or assemblies under actual fire conditions.

1.5.1 Additional information regarding the targets, the test conditions, and test limitations are provided in the annex.

1.6 Fire testing is inherently hazardous. Adequate safeguards for personnel and property shall be employed in conducting these tests.

1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 7.

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Terminology
2	Summary of Test Method Significance and Use FIG. 1
3	Interferences Apparatus FIG. 2
4	FIG. 3 FIG. 4
5	FIG. 5
6	FIG. 6
7	FIG. 7
8	FIG. 8
9	FIG. 9 FIG. 10
10	Hazards Test Specimens Calibration of Apparatus FIG. 11
11	Equipment and Specimen Preparation Procedure
12	Calculation Report Precision and Bias Keywords
13	A1. Discussion on the Important Factors in the Measurement of Corrosion Using the Cone Corrosimeter A1.1 Introduction A1.2 Corrosion Measurements A1.3 Gas Sampling Design
14	A1.4 Use of Data

Additional information

Standard Title	D5485-11 Standard Test Method for Determining the Corrosive Effect of Combustion Products Using the Cone Corrosimeter
Published Code	ASTM
Publication Date	2011
Pages Count	14
ICS Codes	13.040.40 - Stationary source emissions

Preview PDF


PDF Format	Searchable	Printable	Preview Now

ASTM-D5485 2011

PDF Catalog

Related products