ASTM-D6262 1998

$40.63

D6262-98 Standard Specification for Extruded, Compression Molded, and Injection Molded Basic Shapes of Poly(aryl ether ketone) (PAEK)

Published By	Publication Date	Number of Pages
ASTM	1998	9

Guaranteed Safe Checkout

Category: ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

ASTM D6262-98

Historical Standard: Standard Specification for Extruded, Compression Molded, and Injection Molded Basic Shapes of Poly(aryl ether ketone) (PAEK)

ASTM D6262

Scope

1.1 This specification covers requirements and methods of test for material, dimensions, and workmanship, and the properties of extruded, compression molded, and injection molded PAEK sheet, plate, rod, and tubular bar manufactured from PAEK.

1.2 The properties included in this specification are those required for the compositions covered. Requirements necessary to identify particular characteristics important to specialized applications may be described by using the classification system given in Section 4.

1.3 This specification allows the use of key clad plastics (see Section 4).

1.4 The values are stated in inch-pound units and are regarded as the standard in all property and dimensional tables. For reference purposes, SI units are also included in Table 1.

1.5 The following precautionary caveat pertains only to the test method portion Section 11, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

PAEK; plates-PAEK; recycled-PAEK; recycled plastic; rod-PAEK; shapes-PAEK; sheet-PAEK; tubular bar-PAEK

ICS Code

ICS Number Code n/a

DOI: 10.1520/D6262-98


PDF Format	Searchable	Printable	Preview Now

Standard Title	D6262-98 Standard Specification for Extruded, Compression Molded, and Injection Molded Basic Shapes of Poly(aryl ether ketone) (PAEK)
Published Code	ASTM
Publication Date	1998
Pages Count	9

ASTM-D6262 1998

ASTM D6262-98

Historical Standard: Standard Specification for Extruded, Compression Molded, and Injection Molded Basic Shapes of Poly(aryl ether ketone) (PAEK)

ASTM D6262

Related products