ASTM-E209 2005

$40.63

E209-00(2005) Standard Practice for Compression Tests of Metallic Materials at Elevated Temperatures with Conventional or Rapid Heating Rates and Strain Rates

Published By	Publication Date	Number of Pages
ASTM	2005	7

Guaranteed Safe Checkout

Categories: 77.040.10 - Mechanical testing of metals, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

1.1 This practice covers compression test in which the specimen is heated to a constant and uniform temperature and held at temperature while an axial force is applied at a controlled rate of strain.Note 1In metals with extremely high elastic limit or low modulus of elasticity it is conceivable that 1.5 percent total strain under load could be reached before the 0.2 percent-offset yield strength is reached. In this event the 0.2 percent-offset yield strength will be the end point of the test unless rupture occurs before that point.

Note 2

For acceptable compression tests it is imperative that the specimens not buckle before the end point is reached. For this reason the equipment and procedures, as discussed in this recommended practice, must be designed to maintain uniform loading and axial alignment.

1.2 Preferred conditions of testing are recommended so that data from different sources conducting the tests will be comparable.

1.3 The values stated in inch-pound units are to be regarded as the standard.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Apparatus
2	Heating Apparatus Test Specimen FIG. 1
3	FIG. 2 FIG. 3
4	Temperature Control FIG. 4
5	Temperature Measurement Strain Rate During Test Strain Measurement
6	Qualification of Test Apparatus Report REFERENCES

Additional information

Standard Title	E209-00(2005) Standard Practice for Compression Tests of Metallic Materials at Elevated Temperatures with Conventional or Rapid Heating Rates and Strain Rates
Published Code	ASTM
Publication Date	2005
Pages Count	7
ICS Codes	77.040.10 - Mechanical testing of metals

Preview PDF


PDF Format	Searchable	Printable	Preview Now

ASTM-E209 2005

PDF Catalog

Related products