ASTM-E2113:2023 Edition

$34.13

E2113-23 Standard Test Method for Length Change Calibration of Thermomechanical Analyzers

Published By	Publication Date	Number of Pages
ASTM	2023	5

Guaranteed Safe Checkout

Categories: 83.080.01 - Plastics in general, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM E2113-23

Active Standard: Standard Test Method for Length Change Calibration of Thermomechanical Analyzers

ASTM E2113

Scope

1.1 This test method describes calibration of the length change (deflection) measurement or thermal expansion of thermomechanical analyzers (TMAs) within the temperature range from –150 °C to 1000 °C using the thermal expansion of a suitable reference material.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Keywords

calibration; coefficient of thermal expansion; deflection; expansion; expansivity; thermal analysis; thermal expansion; thermomechanical analyzer (TMA);

ICS Code

ICS Number Code 83.080.01 (Plastics in general)

DOI: 10.1520/E2113-23

Additional information

Standard Title	E2113-23 Standard Test Method for Length Change Calibration of Thermomechanical Analyzers
Published Code	ASTM
Publication Date	2023
Pages Count	5
ICS Codes	83.080.01 - Plastics in general