Shopping Cart

No products in the cart.

ASTM-E2266 2004

$44.96

E2266-04 Standard Guide for Design and Construction of Low-Rise Frame Building Wall Systems to Resist Water Intrusion

Published By Publication Date Number of Pages
ASTM 2004 15
Guaranteed Safe Checkout
Categories: ,

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. Weā€™re here to assist you 24/7.
Email:[email protected]

1.1 This guide describes design, specification, selection, installation, and inspection of new building wall systems, exterior deck and stair components, doors, windows, penetrations and sealant joints of wood and metal frame buildings, typically four stories or less, to minimize water intrusion.

1.2 This guide does not address prevention of damage caused by water originating from the use of wet building materials or from indoor or outdoor humidity. Water from these sources can be important, and the potential for damage caused by water from these sources must not be overlooked in building design or construction.

1.3 This guide does not address roofing systems, except when the surface of a deck also serves as a roof and at locations where roof systems interface with building walls.

1.4 This guide does not address any type of barrier wall system.

1.5 This guide does not address any exterior insulation and finish system (EIFS).

1.6 This guide does not address foundation conditions where the bottom of a slab on grade or the grade of a crawl space is at or below the water table or subject to hydrostatic pressure.

1.7 This guide is intended to supplement and not duplicate building code requirements.

1.8 Maintenance, although important, is not covered in detail.

1.9 Application of finishes, such as paint and sealers, may be important in the performance of some types of cladding; however, this is not covered in detail.

1.10 This standard applies only to constructions with sheathing, which facilitates installation of the weather-resistive barrier and associated flashings in a common plane.

This standard may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use.

1.11 Organization of Document

SectionScope Referenced Documents Terminology Summary of Guide Significance and Use General Design Principles Design Practices General Guidelines Drainage Walls Drainage Walls-General Drainage Wall Cladding-Portland Cement Plaster (Stucco) Drainage Wall Cladding-Wood and Wood-Derived Products Drainage Wall Cladding-Vinyl Siding Drainage Wall Cladding-Fiber-Cement Siding Cavity Drainage Walls Cavity Drainage Walls-General Cavity Drainage Wall Cladding-Masonry Wood Framed Decks and Stairs with Exposed Framingand Decking Plaza Decks or Stairs with Enclosed Framing and aWaterproofing Membrane with Separate Wearing Surfaces Plaza Decks or Stairs with Enclosed Framing and aWaterproofing Membrane with an Integral Wearing Surface Windows, Doors, and Similar Wall Penetrations Special Wall Configuration Exterior Sealant Joints Keywords Appendix-Additional Resources

PDF Catalog

PDF Pages PDF Title
1 Scope
Referenced Documents
4 Terminology
6 Summary of Guide
Significance and Use
General Design Principles
7 Design Practices
8 General Guidelines
Drainage Walls
11 Cavity Drainage Walls
Wood Framed Decks or Stairs with Exposed Framing and Decking
12 Plaza Decks or Stairs with a Protected Waterproofing Membrane
Plaza Decks or Stairs with an Integral-Wearing Surface Waterproofing Membrane
13 Windows, Doors and Similar Wall Penetrations
Special Wall Configurations
14 Exterior Sealant Joints
Keywords
X1. ADDITIONAL RESOURCES
X1.1
ASTM-E2266 2004
$44.96