ASTM-E502 2006

$40.63

E502-06 Standard Test Method for Selection and Use of ASTM Standards for the Determination of Flash Point of Chemicals by Closed Cup Methods

Published By	Publication Date	Number of Pages
ASTM	2006	6

Guaranteed Safe Checkout

Categories: 71.080.01 - Organic chemicals in general, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM E502-06

Historical Standard: Standard Test Method for Selection and Use of ASTM Standards for the Determination of Flash Point of Chemicals by Closed Cup Methods

ASTM E502

Scope

1.1 This test method covers the determination of the flash point of liquid and solid chemical compounds flashing from below 10 to 370°C (16 to 700°F). The procedures and apparatus in Test Methods D 56, D 93, D 3278, D 3828, and D 3941 are to be used. Modification to these procedures are specified for tests on solids and viscous liquids. The significance of the results obtained is discussed along with possible sources of error and factors that might cause interference.

1.2 Suggestions for adapting this procedure to mixtures of chemicals are included (see Appendix X2).

1.3 This test method should be used to measure and describe the properties of materials, products, or assemblies in response to heat and flame under controlled laboratory conditions and should not be used to describe or appraise the fire hazard or fire risk of materials or assemblies under actual fire conditions. However, results of this test method may be used as elements of a fire risk assessment that take into account all of the factors that are pertinent to an assessment of the fire hazard of a particular end use.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. See also Section 8.

Keywords

chemicals-fire testing; flash point-liquids; solid phase materials; flash point of chemicals by closed cup methods

ICS Code

ICS Number Code 71.080.01 (Organic chemicals in general)

DOI: 10.1520/E0502-06

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Terminology Summary of Test Method
2	Significance and Use Interferences Apparatus Hazards Preparation of Sample Preparation of Apparatus
3	Calibration Procedure
4	Corrections for Barometric Pressure Report Precision and Bias TABLE 1
5	X1. COMMENTARY ON THE FLASH POINT TEST X1.1 X1.2 X1.3 X1.4 TABLE 2
6	X2. COMMENTARY ON THE FLAMMABILITY OF MIXTURES X2.1 X2.2 X2.3 X2.4

Additional information

Standard Title	E502-06 Standard Test Method for Selection and Use of ASTM Standards for the Determination of Flash Point of Chemicals by Closed Cup Methods
Published Code	ASTM
Publication Date	2006
Pages Count	6
ICS Codes	71.080.01 - Organic chemicals in general