šŸ”„šŸ”„ Donā€™t Miss Out on Our End of Autumn Sale. If you have any questions, feel free to click the bottom right corner to contact our customer service..

Concat us[email protected]
Shopping Cart

No products in the cart.

šŸ”
ASTM-E814:2010 Edition

ASTM-E814:2010 Edition

$44.96

E814-10 Standard Test Method for Fire Tests of Penetration Firestop Systems

Published By Publication Date Number of Pages
ASTM 2010 12
PDF Format Searchable Printable Preview Now
Guaranteed Safe Checkout
Categories: ,

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. Weā€™re here to assist you 24/7.
Email:[email protected]

1.1 This test method is applicable to firestop systems of various materials and construction. Firestop systems are intended for use in openings in fire-resistive walls and floors that are evaluated in accordance with Test Methods E119 .

1.2 Tests conducted in conformance with this test method record firestop system performance during the test exposure; but such tests shall not be construed to determine suitability of the firestop system for use after test exposure.

1.3 This test method also measures the resistance of firestop systems to an external force stimulated by a hose stream. However, this test method shall not be construed as determining the performance of the firestop system during actual fire conditions when subjected to forces such as failure of cable support systems and falling debris.

1.4 The intent of this test method is to develop data to assist others in determining the suitability of the firestops for use where fire resistance is required.

1.5 This test method does not apply to membrane penetrations of a floor-ceiling assembly or roof-ceiling assembly that are tested as part of the assembly in accordance with Test Methods E119 .

1.6 This test method does not apply to membrane penetrations of load-bearing walls.

1.7 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.8 This standard is used to measure and describe the response of materials, products, or assemblies to heat and flame under controlled conditions, but does not by itself incorporate all factors required for fire-hazard or fire-risk assessment of materials, products, or assemblies under actual fire conditions .

1.9 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.10 The text of this standard references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered requirements of the standard.

PDF Catalog

PDF Pages PDF Title
1 Scope
Referenced Documents
2 Terminology
Summary of Test Method
Significance and Use
Control of Fire Tests
FIG. 1
3 FIG. 2
4 FIG. 3
FIG. 4
5 Test Specimen
Protection and Conditioning
6 Conduct of Tests
Rating Criteria
Report
TABLE 1
7 Precision and Bias
8 A1. STANDARD TEMPERATURE-TIME CURVE FOR CONTROL OF FIRE TESTS
9 A2. REQUIREMENTS FOR THERMOCOUPLE PADS
A2.1
A2.2
X1. DISCUSSION OF SEVERAL ITEMS IN THIS TEST METHOD
X1.1 Introduction
X1.2 Applicability
X1.3 Criteria
10 X1.4 Test Specimen
11 X1.5 Conduct of Tests
12 REFERENCES

Related products

ASTM-E814
$44.96