ASTM-F2945 2012

$44.96

F2945-12a Standard Specification for Polyamide 11 Gas Pressure Pipe, Tubing, and Fittings

Published By	Publication Date	Number of Pages
ASTM	2012	15

Guaranteed Safe Checkout

Categories: 23.040.20 - Plastics pipes, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM F2945-12a

Historical Standard: Standard Specification for Polyamide 11 Gas Pressure Pipe, Tubing, and Fittings

ASTM F2945

Scope

1.1 This specification covers requirements and test methods for the characterization of polyamide 11 pipe, tubing, and fittings for use in fuel gas piping. The pipe and fittings covered by this specification are intended for use in the transport of fuel gases.

1.1.1 This specification does not cover threaded pipe. Generic fusion guidelines are given in Appendix X1. Design considerations are discussed in Appendix X2. In-plant quality control programs are specified in Annex A1.

1.2 The text of this specification references notes, footnotes, and appendixes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the specification.

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4 The following is an index of the annexes and appendixes in this specification:

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1—Heat fusion joining of PA11 pipe and fittings meeting the requirements of this standard is limited to PA11 pipe and fittings meeting the requirements of this Standard. Heat Fusion joining of PA11 pipe and fittings meeting the requirements of this standard is not allowed to pipes and fittings made from any other thermoplastic materials (for example, PA12, PEs, PVCs, etc.).

Keywords

ICS Code

ICS Number Code 23.040.20 (Plastic pipes)

DOI: 10.1520/F2945-12A

Additional information

Appendixes	Subject
Annexes	Subject
Annex A2	PA-11 Butt Fusion Fittings
Annex A1	In-Plant Quality Control for sizes up to 12 in.
Appendix X1	Butt Fusion Guidelines for PA-11 Piping
Appendix X2	Design Consideration
ICS Codes	23.040.20 - Plastics pipes