BS EN 13601:2013
$167.15
Copper and copper alloys. Copper rod, bar and wire for general electrical purposes
| Published By | Publication Date | Number of Pages |
| BSI | 2013 | 34 |
This European Standard specifies the composition, property requirements including electrical properties, and tolerances on dimensions and form for copper rod, bar and wire for general electrical purposes. Cross sections and size ranges are: – round, square and hexagonal rod with diameters or widths across flats from 2 mm up to and including 160 mm; – bar with thicknesses from 2 mm up to and including 40 mm and widths from 3 mm up to and including 200 mm; – round, square, hexagonal and rectangular wire with diameters or widths across flats from 2 mm up to and including 25 mm, as well as thicknesses from 0,5 mm up to and including 12 mm with widths from 1 mm up to and including 200 mm. The sampling procedures and test methods for verification of conformity to the requirements of this standard are also specified. NOTE Drawn, round copper wire – plain or tinned, single or multiline – for the manufacture of electrical conductors is specified in EN 13602.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 8 | 1 Scope 2 Normative references |
| 9 | 3 Terms and definitions 4 Designations 4.1 Material 4.1.1 General 4.1.2 Symbol 4.1.3 Number |
| 10 | 4.2 Material condition 4.3 Product |
| 11 | 5 Ordering information |
| 13 | 6 Requirements 6.1 Composition 6.2 Mechanical properties 6.3 Bending characteristics 6.4 Electrical properties 6.5 Freedom from hydrogen embrittlement 6.6 Dimensions and tolerances 6.6.1 Diameter or width across-flats 6.6.2 Corner configuration 6.6.2.1 General |
| 14 | 6.6.2.2 Sharp corners 6.6.2.3 Rounded corners 6.6.2.4 Semi-circular edge 6.6.3 Length 6.6.3.1 General 6.6.3.2 Manufactured lengths (ML) |
| 15 | 6.6.3.3 Fixed lengths (FL) 6.7 Form tolerances 6.7.1 General 6.7.2 Twist |
| 16 | 6.7.3 Straightness 6.7.4 Flatness of bar |
| 17 | 6.8 Wire in coils 6.9 Mass tolerances 6.10 Surface condition 7 Sampling 7.1 General 7.2 Analysis |
| 18 | 7.3 Mechanical and electrical tests 8 Test methods 8.1 Analysis 8.2 Tensile test 8.3 Hardness test 8.4 Bend test 8.5 Electrical resistivity test |
| 19 | 8.6 Hydrogen embrittlement test 8.7 Retests 8.8 Rounding of results 9 Declaration of conformity and inspection documentation 9.1 Declaration of conformity 9.2 Inspection documentation |
| 20 | 10 Marking, packaging, labelling |
| 29 | Annex A (informative) Characteristics of coppers for electrical purposes A.1 General grouping of copper types A.2 General characteristics A.3 Particular characteristics |
