BS EN 60904-8-1:2017
$102.76
Photovoltaic devices – Measurement of spectral responsivity of multi-junction photovoltaic (PV) devices
Published By | Publication Date | Number of Pages |
BSI | 2017 | 20 |
This part of IEC 60904 gives guidance for the measurement of the spectral responsivity (SR) of multi-junction photovoltaic devices. It is principally intended for non-concentrating devices, but parts may be applicable also to concentrating multi-junction PV devices. The SR is required for analysis of measured current-voltage characteristics of multi-junction PV devices as described in IEC 60904-1-1.
The requirements for measurement of SR of single-junction PV devices are covered by IEC 60904-8, whereas this document describes the additional requirements for the measurement of SR of multi-junction PV devices. This document only considers the measurement of SR of individual junction layers within a two-terminal multi-junction device.
This document may be applicable to PV devices designed for use under concentrated irradiation if they are measured without the optics for concentration.
PDF Catalog
PDF Pages | PDF Title |
---|---|
2 | undefined |
5 | Annex ZA(normative)Normative references to international publicationswith their corresponding European publications |
7 | English CONTENTS |
8 | FOREWORD |
10 | 1 Scope 2 Normative references 3 Terms and definitions |
11 | 4 General considerations 5 Bias light 6 Bias voltage |
12 | 7 Apparatus 7.1 General 7.2 Apparatus for measurement of SR using continuous light source |
13 | 7.3 Apparatus for measurement of SR using pulsed light source 7.4 Apparatus for measurement of series-connected modules 8 Measurement of SR 8.1 Measurement of SR using continuous light source 8.2 Measurement of SR using pulsed light source 8.3 Measurement of series-connected modules 9 Correction of measured SR 9.1 General |
14 | 9.2 Correction for shunting 9.3 Correction for luminescent coupling 9.3.1 General |
15 | 9.3.2 Correcting the SR of the second junction (for the coupling J1 -> J2) 9.3.3 Correcting the SR of the third junction (for the coupling J1 -> J2 and J2 -> J3) |
16 | 9.3.4 Correcting the SR of the fourth (or higher) junction 10 Report |
18 | Bibliography |