BS EN IEC 61169-64:2019
$142.49
Radio frequency connectors – Sectional specification. RF coaxial connectors with 0,8 mm inner diameter of outer conductor. Characteristic impedance 50 Ω (type 0,8)
| Published By | Publication Date | Number of Pages |
| BSI | 2019 | 28 |
IEC 61169-64:2019, which is a sectional specification (SS), provides information and rules for the preparation of detail specifications (DS) for IEC 61169 (all parts) coaxial connectors with 0,8 mm coupling. The connectors are used with cables with characteristic impedance 50 ? in an operating frequency range up to 145 GHz. The connectors are widely used in communications and measurements. It describes the interface dimensions for general purpose connectors with gauging information and the mandatory tests selected from IEC 61169-1, applicable to all detail specifications relative to type 0,8 connectors. This specification indicates the recommended performance characteristics to be considered when writing a DS and covers all tests schedules and inspection requirements.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 2 | undefined |
| 5 | Annex ZA(normative)Normative references to international publicationswith their corresponding European publications |
| 7 | English CONTENTS |
| 9 | FOREWORD |
| 11 | 1 Scope 2 Normative references |
| 12 | 4 Mating face and gauge information 4.1 Dimensions – General connectors 4.1.1 Connector with pin-centre conductor Figures Figure 1 – Connector with pin centre conductor Tables Table 1 – Dimensions of connector with pin-centre contact |
| 13 | 4.1.2 Connector with socket-centre contact Figure 2 – Connector with socket centre conductor Table 2 – Dimensions of connector with socket-centre conductor |
| 14 | 4.2 Gauges for general purpose connectors 4.2.1 Gauge pins for socket centre contact 4.2.2 Test procedure Figure 3 – Gauge pin for socket-centre contact Table 3 – Dimensions of gauge pin for socket-centre contact |
| 15 | 4.3 Dimensions – Standard test connectors – Grade 0 4.3.1 Connector with pin-centre contact Figure 4 – Connector with pin centre conductor Table 4 – Dimensions of connector with pin-centre contact |
| 16 | 4.3.2 Connector with socket-centre contact Figure 5 – Connector with socket centre conductor Table 5 – Dimensions of connector with socket-centre contact |
| 17 | 5 Quality assessment procedures 5.1 General 5.2 Ratings and characteristics (see Clause 5 of IEC 61169-1:2013) Table 6 – Rating and characteristics |
| 19 | 5.3 Test schedule and inspection requirements 5.3.1 Acceptance tests 5.3.2 Periodic tests Table 7 – Acceptance tests |
| 20 | 5.4 Procedures for the quality conformance 5.4.1 Quality conformance inspection Table 8 – Periodic tests |
| 21 | 5.4.2 Qualification approval and its maintenance 6 Instructions for preparation of detail specifications 6.1 General 6.2 Identification of the component 6.3 Performances 6.4 Marking, ordering information and related matters |
| 22 | 6.5 Selection of tests, test conditions and severities 6.6 Blank detail specification pro-forma for type 0,8 connector |
| 26 | 7 Marking 7.1 Marking of component |
| 27 | 7.2 Marking and contents of package |
