BSI 17/30334978 DC:2017 Edition
$13.70
BS EN 62946-01. Connectors for electronic equipment. Part 01. Rectangular connectors. Detail specification for 8-way, shielded, free and fixed high density connectors for data transmission with frequencies up to 100 MHz and with current carring capacity up to 1A
| Published By | Publication Date | Number of Pages |
| BSI | 2017 | 33 |
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 6 | FOREWORD |
| 8 | INTRODUCTION |
| 10 | 1 Scope 2 Normative references |
| 11 | 3 Terms and definitions 3.1 Intermateability 3.2 Interoperability |
| 12 | 3.3 Category 4 Mating information 4.1 General 4.2 Contacts – mating conditions |
| 13 | 4.3 Fixed female connector |
| 16 | 4.4 Free male connector |
| 20 | 5 Characteristics 5.1 General 5.2 Pin and pair grouping assignment 5.3 Classification into climatic category 5.4 Electrical characteristics 5.4.1 Voltage proof |
| 21 | 5.4.2 Current-temperature derating 5.4.3 Initial insulation resistance |
| 22 | 5.5 Transmission characteristics 5.5.1 General 5.5.2 Insertion loss 5.5.3 Return loss 5.5.4 Near end cross talk 5.5.5 Far end cross talk 5.5.6 Transverse conversion loss 5.5.7 Transfer conversion transfer loss |
| 23 | 5.6 Mechanical characteristics 5.6.1 Mechanical operation 5.6.2 Insertion and withdrawal forces 6 Tests and test schedule 6.1 General |
| 24 | 6.2 Arrangement for contact resistance measurement 6.2.1 Contact resistance calculation method |
| 25 | 6.3 Arrangement for vibration test (test phase EP5) 6.4 Test procedures and measuring methods 6.5 Preconditioning |
| 26 | 6.6 Test schedules 6.6.1 Basic (minimum) test schedule 6.6.2 Full test schedule 6.6.2.1 General 6.6.2.2 Test group P – preliminary 6.6.2.3 Test group AP – Mechanical endurance |
| 28 | 6.6.2.4 Test group BP – Climatic |
| 29 | 6.6.2.5 Test group CP – Corrosion 6.6.2.6 Test group DP – Moisture |
| 30 | 6.6.2.7 Test group EP – Dynamic stress |
| 31 | 6.6.2.7.1 Test group FP-Latch and cable stress |
| 32 | 6.6.2.8 Test group GP– Signal integrity |
