EIA 60115-9-1-2014

INTRODUCTION

Blank detail specification

A blank detail specification is a supplementary document to the
sectional specification and contains requirements for style, layout
and minimum content of detail specifications. Detail specifications
not complying with these requirements may not be considered as
being in accordance with IEC specifications nor shall they be so
described.

In the preparation of detail specifications the content of 1.4
of the sectional specification shall be taken into account.

The numbers between square brackets on the first page of the
detail specification correspond to the following information which
shall be inserted in the position indicated.

Identification of the detail specification

[1] The "International Electrotechnical Commission" or the
National Standards Organization under whose authority the detail
specification is drafted.

[2] The IEC or National Standards number of the detail
specification, date of issue and any further information required
by the national system.

[3] The number and issue number of the IEC or national generic
specification.

[4] The IEC number of the blank detail specification.

Identification of the resistor network

[5] A short description of the type of resistor network.

[6] Information on typical construction (when applicable).

[7] Outline drawing with main dimensions which are of importance
for interchangeability and/or reference to the national or
international documents for outlines. Alternatively, this drawing
may be given in an annex to the detail specification.

[8] Application or group of applications covered and/or
assessment level.

[9] Reference data on the most important properties, to allow
comparison between the various resistor network types.