SMACNA SheetMetalInspectionGuide 2004 01
$44.96
Architectural Sheet Metal Inspection Guide, 1st Edition
| Published By | Publication Date | Number of Pages |
| SMACNA | 2004 | 52 |
An invaluable inspection resource for owners of standing seam, batten seam, or Bermuda-type roofs. Presents practical troubleshooting and corrective tips for typical problems of roof panels, gutters, downspouts, fascia, copings, flashing, ridges and hips, valleys, expansion joints, penetrations, fasteners and soldering. Also provides relevant information regarding construction of these architectural elements, the purpose of each, as well as what to look for during periodic inspections. Sealants, moisture transfer methods and air leakage are also covered. Emphasizes the importance of regular and appropriately timed inspections because a small problem discovered early can be fixed at a low cost, preventing minor damage from becoming a substantial problem until the cost of repair and remediation becomes excessive. Contractors will find this book a valuable resource to provide owners or facility managers along with the standard building completion documents.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 5 | FOREWORD |
| 7 | NOTICE TO USERS OF THIS PUBLICATION |
| 11 | TABLE OF CONTENTS |
| 15 | CHAPTER 1 INTRODUCTION 1.1 CUSTOM METAL ROOF INSPECTION |
| 19 | CHAPTER 2 INSPECTION GUIDELINES BY ARCHITECTURAL ELEMENT 2.1 ROOF PANELS |
| 20 | FIGURE 2-1 FLAT SEAM ROOFS FIGURE 2-2 STANDING SEAM ROOFS |
| 21 | FIGURE 2-3 BATTEN SEAM ROOFS FIGURE 2-4 BERMUDA TYPE ROOFS |
| 22 | 2.2 GUTTERS 2.3 DOWNSPOUTS |
| 23 | FIGURE 2-5 BUILT-IN GUTTER FIGURE 2-6 GUTTER SCREENS |
| 24 | 2.4 FASCIA FIGURE 2-7 CAP FASCIA—INSTALLATION |
| 25 | 2.5 COPINGS FIGURE 2-8 FORMED METAL COPING |
| 26 | 2.6 FLASHING |
| 27 | FIGURE 2-9 COUNTER FLASHING SYSTEMS—EXAMPLES |
| 28 | 2.7 RIDGES AND HIPS |
| 29 | FIGURE 2-10 HIP AND RIDGE FLASHING |
| 30 | 2.8 VALLEYS |
| 31 | FIGURE 2-11 VALLEY FLASHING |
| 32 | 2.9 EXPANSION JOINTS |
| 33 | FIGURE 2-12 BUILDING EXPANSION JOINTS—ROOF |
| 34 | 2.10 PENETRATIONS |
| 35 | FIGURE 2-13 ROOF PANEL PENETRATION |
| 36 | 2.11 FASTENERS 2.12 SOLDERING |
| 39 | CHAPTER 3 INSPECTION PROCEDURES 3.1 INTERIOR INSPECTION |
| 40 | 3.2 EXTERIOR INSPECTION 3.3 ROOF INSPECTION |
| 43 | APPENDIX A SEALANTS A.1 SEALANTS |
| 47 | APPENDIX B OTHER MOISTURE SOURCES B.1 MOISTURE TRANSFER METHODS B.2 AIR LEAKAGE |
| 48 | ROOF SYSTEM REFERENCE GRID |
| 49 | BUILDING INSPECTION CHECKLIST |
