{"id":63946,"date":"2024-10-17T12:21:45","date_gmt":"2024-10-17T12:21:45","guid":{"rendered":"https:\/\/pdfstandards.shop\/product\/uncategorized\/astm-d4896-2008-2\/"},"modified":"2024-10-24T18:12:56","modified_gmt":"2024-10-24T18:12:56","slug":"astm-d4896-2008-2","status":"publish","type":"product","link":"https:\/\/pdfstandards.shop\/product\/publishers\/astm\/astm-d4896-2008-2\/","title":{"rendered":"ASTM-D4896 2008"},"content":{"rendered":"<\/p>\n
1.1 This guide is directed toward the safe and appropriate use of strength values obtained from test methods using single-lap adhesive joint specimens.<\/p>\n
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.<\/p>\n
1.3 The discussion focuses on shear strength as measured with small thin-adherend, single-lap specimens. Many factors, however, apply to shear modulus, tensile strength, and tensile modulus measured by small laboratory specimens in general. This discussion is limited to single-lap specimens and shear strength only for simplification.<\/p>\n
PDF Pages<\/th>\n | PDF Title<\/th>\n<\/tr>\n | ||||||
---|---|---|---|---|---|---|---|
1<\/td>\n | Scope Referenced Documents <\/td>\n<\/tr>\n | ||||||
2<\/td>\n | Terminology <\/td>\n<\/tr>\n | ||||||
3<\/td>\n | Significance and Use Considerations for the Analysis of Small Single-Lap Specimen Test Results <\/td>\n<\/tr>\n | ||||||
4<\/td>\n | FIG. 1 <\/td>\n<\/tr>\n | ||||||
5<\/td>\n | Acceptable Uses of Thin-Adherend, Single-Lap Specimen Tests Tests for Developing Adhesive Design-Shear Stresses Keywords <\/td>\n<\/tr>\n | ||||||
6<\/td>\n | REFERENCES <\/td>\n<\/tr>\n<\/table>\n","protected":false},"excerpt":{"rendered":" D4896-01(2008)e1 Standard Guide for Use of Adhesive-Bonded Single Lap-Joint Specimen Test Results<\/b><\/p>\n |